But not always the hard drive situation is so good. In the case of mechanical damage, the operating system is unlikely to be restored. Therefore, to recover data from a damaged hard drive, you will need to use additional utilities that can be relatively conditionally distributed in the following directions:
- Direct repair of the damaged disk information;
- Create an image for subsequent file recovery;
- Recovering deleted data after formatting;
- Hard disk resuscitation in the event of critical failures, both mechanical and programmed.
Here are a few key programs of each category that are considered the best in their industry. For the data recovery miami fl this is important.
What are the conditions that need to be met before the recovery of data from the damaged hard drive is required?
Now we have a little more attention! When it comes to damage to the hard disk itself, it is strictly forbidden to manipulate it, and the software used must be installed on another hard disk or external USB-HDD. In addition, to recover data from a damaged drive, it is desirable to remove it from the system module or laptop, put it in a special external pocket, and connects to another computer. The exception is the situation if one of the disks belongs to the RAID array or is external. When using applications for the usual recovery of deleted files, say after formatting, you can install them on the hard drive better on the logical tab but copy the information in the tab that should work in the future before the scan starts.
Recover Data from a Damaged Hard Drive: ZAR Program
Now go directly to about the necessary information and use the Zero Assumption Recovery utility, which should not be downloaded or installed on the problem HDD. As mentioned previously, the disk is first connected to another computer. For the proper functioning of the program, you must immediately disable the antivirus program the utility will notify you about the need to disable the program.
In the current program, you must first click the “Recover Data for Windows and Linux” button so that you can find all the media connected to the computer, then mark the media and initiate the scanning process. The results will show found folders that need to be tagged.
At the final stage, the data recovery process from an external hard disk will be reduced to copying the content found to another location where you want to set the path, and then click the startup button Run Copy Selected Files”). Once the process is complete, the stored information can be used.
Actions to load Hiren’s Boren CD
Another technique used when the hard disk cannot be booted is to use external boot loader. Pre-creation of such an image carrier is quite simply possible in any convenient program such as Ultra ISO for optical drives or Rufus for flash drives.
After downloading the Windows Graphic Mode selection user interface and when starting a computer with an HDD problem, the main menu should use the restoration of information, determine the type of action, for example, the recovery of deleted data partitioning partitions, etc. by selecting one of the tools presented in the submenu. Note that it is not useful to use the Recuva embedded applet; it will not work yet. It is best to use the DiskDigger utility, Photo Recovery, or System Restore.
